Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
84 BII Clutch problems
Replies: 5
by
84BII33s »
Wed Jan 25, 2006 4:01 pm
I have an '84 Bronco II with a toyo kyogo 4-speed that won't shift into gear. The clutch hydraulic line was found to be empty. I check it once a...
5 Replies
4084 Views
Last post by ranger5.0
Thu Mar 09, 2006 9:26 pm
84 bronco II flywheel replacment
Replies: 8
by
Jesse »
Sun Dec 11, 2005 8:57 pm
I'm Jesse. I have a 84 bronco II with the 2.8L and the 4 speed overdrive tranny. I found out after putting a new starter on it that the flywheel has...
8 Replies
4790 Views
Last post by Michael99
Wed Mar 08, 2006 11:07 am
t case clean
Replies: 4
by
drewski15 »
Mon Mar 06, 2006 5:29 am
my transfer case is covered and mud and I dropped it out yesterday, any suggestions on how to clean it off. Can i just use hot water and soap or will...
4 Replies
1208 Views
Last post by Michael99
Wed Mar 08, 2006 10:49 am
Was there a factory Bronco II diesel?
Replies: 2
by
Al »
Sun Jan 15, 2006 6:47 am
Was there a factory Bronco II diesel? I thought I heard that a small number were built but I could be imagining things.
2 Replies
1450 Views
Last post by bigdog
Tue Mar 07, 2006 11:13 am
stock axle
Replies: 1
by
Stock88 »
Fri Mar 03, 2006 9:33 am
Hello All,
1 Replies
787 Views
Last post by Nobody
Fri Mar 03, 2006 11:09 am
sas
Replies: 1
by
tim roney »
Sat Feb 25, 2006 7:32 pm
got my dana 44 and 9 today and body got any tips on the install?
1 Replies
1083 Views
Last post by madmaxb2
Thu Mar 02, 2006 11:22 am
New interior
Replies: 2
by
COUGBII »
Wed Mar 01, 2006 4:37 pm
Hi all, well i need to redue almost the entire interior of my new 85'. If you all have done this or such, are there headliners, carpet manufacturers...
2 Replies
1202 Views
Last post by ranger5.0
Wed Mar 01, 2006 8:11 pm
Transmission swap
Replies: 3
by
worth165 »
Tue Feb 28, 2006 1:33 pm
I have been told that a 4.0 litre manual transmission out ranger/explorer will bolt to a 2.9litre engine. Fact or Crap.
3 Replies
1463 Views
Last post by DBrown
Tue Feb 28, 2006 5:27 pm
Np205 Years
Replies: 6
by
Dreded »
Mon Feb 13, 2006 10:56 am
I was wondering if anyone knew what years of trucks I can find a ford Np205 in? and how to tell it apart from other t-cases?
6 Replies
2778 Views
Last post by no v8? why drive?
Tue Feb 28, 2006 12:20 pm
reusing a lift!!
Replies: 2
by
Jesse »
Mon Feb 27, 2006 9:39 pm
I recently found a bronco at a junkyard stripped of motor/tranny and windows lol but it has a fairly decent looking lift that looks to be about 6...
2 Replies
1403 Views
Last post by Dreded
Tue Feb 28, 2006 10:04 am
power window motor
Replies: 4
by
bigstevesB2 »
Fri Feb 24, 2006 9:49 am
i was wondering what the best way to change the power window motor in my 86 bronco II on the drivers side.. it looks hard to get to and i wanted to...
4 Replies
1392 Views
Last post by bigstevesB2
Sun Feb 26, 2006 12:53 am
Power steering on 302 conversion
Replies: 5
by
TC »
Thu Feb 09, 2006 7:05 pm
I have the old V-6 pump. Advance Adapters says that you can use a car bracket, but the number that they gave me is no longer being made. Just...
5 Replies
1517 Views
Last post by TC
Sat Feb 25, 2006 1:11 pm
gear pattern
Replies: 7
by
NMB2 »
Wed Feb 22, 2006 4:22 pm
here the pics are Matt :D
7 Replies
3225 Views
Last post by DBrown
Thu Feb 23, 2006 6:07 am
brands of body lifts
Replies: 1
by
1988b2 »
Sun Feb 19, 2006 3:48 pm
i know PA body lifts come with just bolts which screw into the sleves. Are there any brands out there that have bolts AND nuts instead of the sleves?
1 Replies
1020 Views
Last post by DBrown
Sun Feb 19, 2006 5:02 pm
Aftermarket shifter on a 302 conversion
Replies: 4
by
TC »
Thu Feb 09, 2006 7:15 pm
So, on my auto C4, the 4x4 stick pokes through the hole okay, but I know that I will need to get an aftermarket cable shifter so I can use the stock...
4 Replies
2041 Views
Last post by TC
Sun Feb 19, 2006 2:09 pm
Np205 or Dana20
Replies: 10
by
Dreded »
Wed Feb 15, 2006 2:41 pm
Ok iv got a Mazda M5R2 from and F-250 under the BII and the t-case I have(BW1356) is to large so I was wondering what you guys would reccomend the...
10 Replies
4563 Views
Last post by DBrown
Fri Feb 17, 2006 5:07 am
4x4
Replies: 12
by
bigdog »
Wed Feb 01, 2006 8:20 am
how hard would it be to change a push botton 4x4 to a manual shifter
12 Replies
6903 Views
Last post by OffroadBEAR
Thu Feb 16, 2006 3:59 pm
Rear Diff Mesurements.
Replies: 11
by
tekatlarge »
Fri Feb 10, 2006 8:39 am
I got a question bout rear ends!
11 Replies
5963 Views
Last post by tekatlarge
Mon Feb 13, 2006 6:20 pm
hyd steering
Replies: 1
by
tim roney »
Thu Feb 09, 2006 4:19 pm
any body know how to do a cheap hyd ram steering setup?
1 Replies
750 Views
Last post by Rockcrawler
Thu Feb 09, 2006 5:24 pm
what the GhettO BoOty FaB?!?!
Replies: 1
by
NMB2 »
Thu Feb 09, 2006 4:09 am
well the other night..i like broke another drag link...this one actually broke.
1 Replies
962 Views
Last post by Phillippi
Thu Feb 09, 2006 4:52 am
i need a broncoII
Replies: 5
by
Dan »
Wed Jan 25, 2006 5:06 pm
im lookin for a bronco II and i need to kno what the best engine or year is to look for i also need to kno if a regular stock engine would have...
5 Replies
2633 Views
Last post by ranger5.0
Wed Feb 08, 2006 6:50 pm
coil springs
Replies: 10
by
partsman66 »
Fri Jan 20, 2006 3:24 pm
Well I think I've read just about everything.My front coils are sagging a little and I wanna replace them,but I wanna use some that are about 1.5...
10 Replies
4068 Views
Last post by ranger5.0
Wed Feb 08, 2006 6:35 pm
302 Motor incline/decline questions
Replies: 4
by
TC »
Thu Jan 19, 2006 12:55 pm
Hey everyone,
4 Replies
2443 Views
Last post by TC
Sat Feb 04, 2006 1:16 pm
302 swap alternator
Replies: 4
by
TC »
Thu Jan 26, 2006 4:58 pm
Ohhhhh yeah... the engine is in and bolted down! Unfortunately, I think my RX7 rear end went out on the way back up.
4 Replies
1129 Views
Last post by TC
Fri Feb 03, 2006 1:37 pm
ghetto lift!!
Replies: 4
by
Jesse »
Sun Jan 29, 2006 6:19 pm
ok, i decided against going with the 302 (for now) because I really need a ride back & forth to work. I'm going buy the @$&*ing $80 distributor since...
4 Replies
1882 Views
Last post by TC
Fri Feb 03, 2006 1:35 pm
prolem with bronco II at hi rpm
Replies: 5
by
bigdog »
Fri Jan 27, 2006 8:08 am
i got a problem when my bronco II 1986 gets to 3-4000 rpm in every gear it cuts out and i replaced destributer, rotary button, plugs, plug wires and...
5 Replies
2350 Views
Last post by bigdog
Mon Jan 30, 2006 5:41 am
79 bronco axles in an 84 broncoII
Replies: 27
by
BIG Z DUDE »
Fri Jan 20, 2006 3:40 pm
I just need to know if I should take the coil and shock mounts off to or just use the stock bronco II mounts the 79 has 2 shocks on each side of the...
27 Replies
11964 Views
Last post by DBrown
Sun Jan 29, 2006 1:27 pm
little triangles
Replies: 5
by
BIG Z DUDE »
Fri Jan 27, 2006 12:19 pm
On the d44 where the radius arms connect there are to little triangles on each side of the axle that are part of the axle. what do I do, dont I have...
5 Replies
2690 Views
Last post by marinebroncoii
Sat Jan 28, 2006 5:34 am
2 Replies
939 Views
Last post by OffroadBEAR
Fri Jan 27, 2006 8:44 pm
351 cleveland
Replies: 6
by
Dan »
Thu Jan 26, 2006 8:19 pm
what do u think the odds are of getting a 351 cleveland into a bronco II now this may sound overkill or just plain stupid but i can get it for 200...
6 Replies
2543 Views
Last post by ranger5.0
Fri Jan 27, 2006 7:43 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum