Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Drive Shaft
Replies: 25
by
The BII Bandit »
Sun May 14, 2006 2:52 pm
the stock b2 drive shaft seems to be junk (correct me if im wrong). what is a good replacement? it can be out of any vehicle, i live close to a pick...
25 Replies
12958 Views
Last post by BDEUCE
Thu Jan 11, 2007 10:22 am
0 Replies
1327 Views
Last post by bower100
Wed Jan 10, 2007 6:26 pm
Help pulling springs
Replies: 3
by
nickb »
Fri Dec 29, 2006 2:47 pm
OK this might be a stupid question. I'm going to a U-pull it junk yard for explorer spings, I can't take a torch or a generator in the yard. So what...
3 Replies
1774 Views
Last post by bower100
Tue Jan 09, 2007 4:35 pm
Check engine light? Never seen it.
Replies: 14
by
bower100 »
Sun May 14, 2006 3:55 pm
I posted about my engine erratic idling problem and that I wanting to check for any stored error codes. I also mentioned I've never seen the engine...
14 Replies
5587 Views
Last post by bower100
Sun Jan 07, 2007 9:28 am
right side valve cover
Replies: 1
by
84_4x4 »
Fri Jan 05, 2007 9:47 pm
any hints or suggestions to getting to the back bolts on this with the ac condensor in the way on a 84 with a 2.8
1 Replies
839 Views
Last post by Limited
Sat Jan 06, 2007 10:12 am
Auto or Manual Trans
Replies: 8
by
84_4x4 »
Thu Jan 04, 2007 8:56 pm
ive seen people swing both ways on this borad and i wanna get an official count. do you preffer and auto tranny when wheeling or a manual trans and...
8 Replies
3191 Views
Last post by Nobody
Fri Jan 05, 2007 7:03 pm
I think my B2 has a cold...
Replies: 3
by
greenmachine89 »
Mon Jan 01, 2007 6:11 pm
When I get going down the road my B2 sort of coughs or stutters as if it doesn't want to go. I have done all the tune up stuff like new wires and all...
3 Replies
1635 Views
Last post by BDEUCE
Thu Jan 04, 2007 7:13 pm
reverse lights
Replies: 2
by
worth165 »
Wed Jan 03, 2007 8:35 am
i have an issue with my reverse lights. I recently just bought a rebuilt from a trans shop, and is now out of warranty, and I have replace the switch...
2 Replies
1585 Views
Last post by NCBII
Wed Jan 03, 2007 6:56 pm
Does this look right?
Replies: 11
by
Phillippi »
Fri Dec 08, 2006 1:11 pm
I am finally installing the radius arms on my d44 and the bushings dont look right. Its like they are too small and are being smashed into place. Is...
11 Replies
3902 Views
Last post by DBrown
Mon Jan 01, 2007 3:03 pm
o2 sensor
Replies: 3
by
pigmy pony »
Tue Dec 19, 2006 8:11 pm
Does anybody have any tips on getting the oxygen sensor off of this 2.9. I smell a rich exhaust so my first thought is o2 sensor. The problem is I...
3 Replies
1942 Views
Last post by Hair
Sun Dec 31, 2006 3:10 pm
Fuses keep blowing
Replies: 4
by
jwillie »
Fri Dec 08, 2006 7:23 pm
Took the bronco for a spin today and on the way home the blinkers and brake lights stopped working. I replaced the fuse for the brake lights but they...
4 Replies
2372 Views
Last post by tdub
Sun Dec 31, 2006 9:28 am
Gears
Replies: 8
by
Alrebel_09 »
Fri Dec 22, 2006 1:47 pm
My 86 bronco II has something like 3.42 gears. I was going to replace them with either 4.11s or 4.56s. On the Precision Gear website it says When...
8 Replies
4214 Views
Last post by Happy_Jack
Thu Dec 28, 2006 3:04 pm
3.8 swap questions
Replies: 2
by
pigmy pony »
Wed Dec 27, 2006 6:30 pm
Does anybody know any info on swaping a 3.8 out of a 92 tbird. I have the car and was thinking about parting it out but if its relativly easy, I...
2 Replies
1510 Views
Last post by Happy_Jack
Thu Dec 28, 2006 2:36 pm
Oil Dipstick
Replies: 1
by
DOCIRISH_2000 »
Thu Dec 28, 2006 11:49 am
Hi guys,
1 Replies
851 Views
Last post by 84_4x4
Thu Dec 28, 2006 12:39 pm
exploder springs
Replies: 27
by
Flatlander »
Fri Nov 24, 2006 10:53 pm
Picked up a d35, 8.8, springs and a couple seats from the yard today. Question is: I've seen that you should keep the bolts from the springs on the...
27 Replies
13603 Views
Last post by Dogfather
Wed Dec 27, 2006 11:52 am
Fender Trimming
Replies: 5
by
Wheelz »
Sun Dec 03, 2006 9:51 pm
I'm planning on trimming my fenders about 2 inches and was wondering if anyone had any info on how to get all the measurements correctly. I just got...
5 Replies
2510 Views
Last post by Dogfather
Tue Dec 26, 2006 8:00 am
Axles
Replies: 5
by
Alrebel_09 »
Wed Dec 20, 2006 11:49 am
In my 86' Bronco II the axles are dana 25 and ford 7.5. Can I run 35s on these axles without them breaking?
5 Replies
2194 Views
Last post by texastud1983
Mon Dec 25, 2006 12:40 pm
Whistles are for kids not broncos
Replies: 6
by
greenmachine89 »
Fri Dec 15, 2006 10:59 pm
I have a whistle that my 89 B2 does only at a certain rpm and only with a certain amount of throttle. Any gear doesn't matter but when I am going...
6 Replies
2560 Views
Last post by Wheelz
Fri Dec 22, 2006 2:57 pm
Help locating part
Replies: 5
by
Wheelz »
Wed Dec 13, 2006 11:17 am
So i've posted before about how my BII wasn't starting in park and the gear selection was off. Well today I found out why, it turns out that the...
5 Replies
2526 Views
Last post by Wheelz
Fri Dec 22, 2006 2:52 pm
Rims
Replies: 5
by
Alrebel_09 »
Thu Dec 21, 2006 9:54 am
What is the bolt pattern on an 86 bronco and where can i by rims ont the internet for it?
5 Replies
3019 Views
Last post by Wheelz
Fri Dec 22, 2006 2:51 pm
Suspension lift
Replies: 3
by
Alrebel_09 »
Tue Dec 19, 2006 5:05 pm
I have and 86 bronco II with a three inch body lift. Should i buy the suspension lift for the stock setup or save it for a SAS?
3 Replies
1449 Views
Last post by Bob Myers
Wed Dec 20, 2006 6:24 pm
Bronco II modifications
Replies: 4
by
neotes »
Tue Dec 19, 2006 12:19 pm
Hello!
4 Replies
1592 Views
Last post by Phillippi
Tue Dec 19, 2006 11:45 pm
302??
Replies: 1
by
texastud1983 »
Mon Dec 18, 2006 3:29 pm
What do yall think about a fuel injected 5.0 HO out of an 86 crown vic. with auto trany????????
1 Replies
963 Views
Last post by ranger5.0
Tue Dec 19, 2006 9:24 pm
Dana35 locker?
Replies: 2
by
jwillie »
Sun Dec 17, 2006 9:21 pm
I've been considering the purchase of traction assisting defice for my d35 but can't make up my mind which one to get. I an currently running 31's...
2 Replies
1619 Views
Last post by ranger5.0
Tue Dec 19, 2006 9:22 pm
electrical issues
Replies: 1
by
pigmy pony »
Sun Dec 17, 2006 9:03 pm
My 86 bronco 2 has some elctrical problems, and I am not sure what they are. If you are driving at night the lights are dime untill you hit the gas...
1 Replies
944 Views
Last post by 84_4x4
Sun Dec 17, 2006 9:11 pm
13 Replies
9209 Views
Last post by pigmy pony
Sun Dec 17, 2006 9:10 pm
rattle in the front end
Replies: 2
by
mrdoregon »
Wed Dec 13, 2006 7:05 pm
I have a 87 bII auto 4x. when im driving down the road there is this strange rattle that occures. it dosnt vibrate thru the steering and dosnt change...
2 Replies
920 Views
Last post by mrdoregon
Sat Dec 16, 2006 7:46 pm
V8 Swap - many questions
Replies: 3
by
TonkaToyDave »
Sat Dec 09, 2006 2:03 am
Hi, My name's David. I'm new to BII4x4.com, and i think this place is awesome! First thing, i want to say, i know i can search for this information,...
3 Replies
1574 Views
Last post by Bob Myers
Sat Dec 16, 2006 6:45 pm
Winshild wiper linkage bushings
by
84_4x4 »
Tue Dec 12, 2006 8:31 pm
help i cant find them anywhere no auto parts stores have them and i have no wipers becuase mine broke anyone know where i can buy these or have any...
0 Replies
1164 Views
Last post by 84_4x4
Tue Dec 12, 2006 8:31 pm
Hey Bob Meyer
Replies: 6
by
Phillippi »
Fri Dec 08, 2006 2:54 pm
I have a question for you. I know I bought these coil buckets forever ago, but the only way I can get the bolt holes to line up with the holes in the...
6 Replies
2747 Views
Last post by Joel H
Tue Dec 12, 2006 6:50 am
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum