ok guys found out my computer is bad and just to let u know i`am ordering a new one monday....but my question is...does anybody have or know where i...
Hello, I recently purchased a 1984 Ford Bronco II, what a great truck! I need the internal parts and handle for the rear liftgate. I have tried local...
I have a 1990 b2 I have noticed that i am leaking water / antifreeze under the passenger side fender well. Thought it was a cracked engine but looked...
hey guys, i'm new here and i am thinking about buying a bronco II but it needs a water pump replaced, how hard is it?
i'm only 16 and this will be my...
I have a 89' bronco 2 with a 2.9 and im trying to bring it back life after is been in storage due to deployment. my problem is, wont fire up without...
I removed my distributor so I could replace it but I didn't set the engine to top dead center and now the distributor will not mesh up properly with...
I recently read an article about converting the A/C compressor to supply on-board air. Has anyone done this before? If so, I would welcome any advice...
Good evening. I own an 87 b2 that I'm slowely building up. I would like to put an Eco cage on it, one that I would Be building my self. Not for Rock...
I need to stiffen up the rear suspension on my 84 BII. What is a cheap easy way to do that? I am moving cross country soon and i will have my bike in...
I am looking into swaping my runni gear to the explored dana 35 and 8.8. Does anyone have a recomendation on what year to go with and what gear ratio...
i plan on doing a 4 inch rough country on my 89 b2 this next summer but my question is that rough country say that it comes with everything you nedd...
So I go an 89 b2 and when I got it I noticed there was thi ticking noise. I have read a few things about it and talked to a few people that suggested...
Let me start out by saying I am not a mechanic, and I need some help! I have replaced the key lock, and the ignition switch. It appears to me the pin...
yeah definitely a good call on the drive shaft. I replaced mine with a u joint style and it took out a lot of the slack. You might look at the wheel...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
