Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
2 Replies
1148 Views
Last post by 88budget4X4
Sat Jun 14, 2008 11:02 am
Is this bronco worth a damn?
Replies: 15
by
87xjmike »
Tue Jun 10, 2008 1:50 pm
Hey everybody I’m a ford guy at heart and am about to buy my 3rd. I'm going to look at this one later tonight and was hoping for some tips to look...
15 Replies
5000 Views
Last post by vabronconut
Fri Jun 13, 2008 2:03 pm
'89 B2 fuel sending unit
Replies: 2
by
TJDukit82 »
Thu Jun 12, 2008 7:23 am
Does anybody know if the fuel sending unit out of an '83-'85 B2 will fit in my '89 fuel tank. I've already made a fuel pickup for it using the...
2 Replies
981 Views
Last post by TJDukit82
Thu Jun 12, 2008 8:42 pm
1986 BII idling sporadically
Replies: 4
by
sgt4089 »
Wed Jun 11, 2008 7:51 am
2.9 V6 5 speed. It will lope at idle, but give it gas it is fine. Could that be a TPS problem? Bad or out of adjustment. How do you adjust the TPS.
4 Replies
1778 Views
Last post by tekatlarge
Thu Jun 12, 2008 7:24 pm
What gearing do you run?
Replies: 4
by
stevenf »
Mon Jun 09, 2008 8:36 pm
Im building my GM 12 bolt which has 3.73's. Im wanting to run 35's-37's and was wondeirng what gears yall would run with 35's-37's. Would the 3.73's...
4 Replies
1372 Views
Last post by NastyBronco2
Tue Jun 10, 2008 9:28 pm
no wiring for stereo what now?
Replies: 2
by
stupidcow79 »
Sat Jun 07, 2008 7:42 am
just wondering how you could wire up a stereo if there were no factory wires availible just need to no what i should connect to power and stuff
2 Replies
1203 Views
Last post by stupidcow79
Tue Jun 10, 2008 3:21 pm
4BT cummins in a BII
Replies: 8
by
stevenf »
Tue Jun 03, 2008 12:57 pm
Ive been looking at the 4bt cummins that was put in old bread trucks. Anyone know of a good write up about these engines?
8 Replies
5313 Views
Last post by bartmantom
Sun Jun 08, 2008 8:45 pm
Junk yard fender flares?
Replies: 1
by
stevenf »
Sat Jun 07, 2008 4:36 pm
I saw a Jeep Cherokee the other day and I noticed there stock fender flares are about 2 . I will have to trim the fenders on my BII later on and...
1 Replies
1071 Views
Last post by onewontwo
Sun Jun 08, 2008 2:05 pm
Cam lifters
Replies: 4
by
greenmachine89 »
Tue Jun 03, 2008 9:58 am
I have been told by a few people that I need to change out my lifters in my 91 ex because of the ticking i'm getting. Now can i just change the...
4 Replies
1911 Views
Last post by greenmachine89
Sat Jun 07, 2008 7:31 pm
86 B2 Cranks But wont start
Replies: 9
by
LilnaYt207 »
Sun Jun 01, 2008 2:33 pm
OK so i know there a ton of posts about this subject, i have personally read six about this, so i guess starting my own is kind of pointless, but...
9 Replies
2790 Views
Last post by vabronconut
Sat Jun 07, 2008 8:48 am
205 divorce t-case
Replies: 2
by
QuickNCrazy »
Thu Jun 05, 2008 8:34 pm
has anyone shoved a divorced t case ina b2 i got 1 in my 78 ford and i would liek to put the 1ton running gear in b2
2 Replies
1337 Views
Last post by Ranger Dave
Fri Jun 06, 2008 7:52 pm
scout diffs and t-case
Replies: 1
by
QuickNCrazy »
Thu Jun 05, 2008 8:24 pm
are the scout diffs and tcases any good from a 70's scout and are they compatabile at all?
1 Replies
749 Views
Last post by vabronconut
Fri Jun 06, 2008 5:34 am
3 Replies
1479 Views
Last post by Dreded
Thu Jun 05, 2008 4:52 pm
deisel 5.0l?
Replies: 3
by
stevenf »
Mon May 26, 2008 9:26 pm
I thought about this earlier because a friend of mine owns a seafood shop and have hundreds of gallons of vegitable oil each week that I could take....
3 Replies
1851 Views
Last post by Dreded
Thu Jun 05, 2008 4:43 pm
Long term underbody paint?
Replies: 1
by
stevenf »
Tue Jun 03, 2008 8:31 pm
I am abuot to start rebuilding a GM 12 bolt rear for my BII and rust is the first thing I want to get rid of. What have you guys found is the best on...
1 Replies
973 Views
Last post by clem
Wed Jun 04, 2008 5:06 pm
Axle swap build and lift questions
Replies: 16
by
stevenf »
Sat May 24, 2008 3:41 pm
I want to start toying with my BII so I figured the rear axle swap would be the best to start with. I will be putting using an 8.8 , (whatever I can...
16 Replies
6459 Views
Last post by Phillippi
Sun Jun 01, 2008 9:33 pm
Synthetic Winch LIne
Replies: 1
by
jwillie »
Sat May 31, 2008 7:17 pm
It's time to replace my winch cable and I was thinking of using synthetic line. Does anyone have any experience with synthetic's or know were I can...
1 Replies
1049 Views
Last post by TJDukit82
Sat May 31, 2008 8:44 pm
Mustang exhaust manifolds
Replies: 1
by
TJDukit82 »
Fri May 30, 2008 7:16 am
Does anybody know if the exhaust manifolds on my 2.8L from a '78 Mustnag II are the same as the 2.8L that went into the Ranger and Bronco II. I have...
1 Replies
893 Views
Last post by TJDukit82
Sat May 31, 2008 11:21 am
IAC. Where exactly is it?
Replies: 4
by
Krafty10 »
Thu May 29, 2008 12:49 pm
I have an 86 BII, 2.9. I am getting conflicting locations from my repair manual. Can someone please tell me exactly where each item is? Left, right...
4 Replies
1774 Views
Last post by Krafty10
Fri May 30, 2008 8:31 pm
no spark on 88 BII
Replies: 11
by
steven88B2 »
Fri Apr 25, 2008 5:16 pm
im not getting any spark from the coil on my bronco. ive tried changing the coil but still nothing. i have power to the coil but i dont know the next...
11 Replies
3608 Views
Last post by steven88B2
Wed May 28, 2008 11:57 pm
4.0 Ticking
Replies: 6
by
greenmachine89 »
Fri May 23, 2008 10:59 pm
Just bought a '91 Explorer that drove just fine but the other day it began to tick. I have a B2 with a 2.9 and it ticks only when I start it. This...
6 Replies
2589 Views
Last post by greenmachine89
Tue May 27, 2008 1:47 pm
0 Replies
1147 Views
Last post by yoyodyne
Mon May 26, 2008 7:30 pm
'89 B2 With '78 2.8l duraspark
Replies: 1
by
TJDukit82 »
Sat May 24, 2008 9:04 am
So I've changed all the dirstributor parts out and all the electronics for the duraspark are brand new and I'm getting no spark. I have power running...
1 Replies
860 Views
Last post by TJDukit82
Sat May 24, 2008 3:45 pm
drop pitman arm
by
vabronconut »
Fri May 23, 2008 2:25 pm
what pitman arm do you use on a 87 bii with a eb d44 with eb drag link ?
0 Replies
872 Views
Last post by vabronconut
Fri May 23, 2008 2:25 pm
bii or ranger heater box???
Replies: 2
by
vabronconut »
Tue May 20, 2008 5:45 am
did the bii or ranger come without a/c and the air box in the engine compartment without the conderser? my bii had a engine fire that melted the box...
2 Replies
999 Views
Last post by vabronconut
Thu May 22, 2008 7:42 pm
3 Replies
1659 Views
Last post by tekatlarge
Thu May 22, 2008 8:23 am
HOLE IN MY GAS TANK
Replies: 5
by
QuickNCrazy »
Sun May 18, 2008 9:54 pm
I was out 4x4ing and the back end bottomed out in a hole and a rock that was wedged between the gas tank and skid plate poked throught the tank its...
5 Replies
1930 Views
Last post by dRiZzLe3
Wed May 21, 2008 6:58 pm
fuel cell plumbing for anyone that cares
Replies: 4
by
NMB2 »
Tue May 20, 2008 12:28 am
not sure if anyone else is using a fuel cell or has ever had the spilling problem, but I did.
4 Replies
2437 Views
Last post by NMB2
Tue May 20, 2008 11:09 am
bronco clutch pedals
Replies: 2
by
vabronconut »
Sat May 10, 2008 11:30 am
i posted in the parts wanted section with no reply's hopefully someone will see this here, i need a set of clutch brake pedals for a bii or ranger....
2 Replies
956 Views
Last post by vabronconut
Tue May 20, 2008 5:40 am
13 Replies
4017 Views
Last post by orcus420
Mon May 19, 2008 7:29 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum