Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
fuel problem on 2.9
by
bronco_II »
Fri Feb 06, 2009 5:02 am
hey guys ....me again. Im having fuel issues on my 1989 2.9 efi it seems when it warms up it starts to studder. but i put the clutch in rev it up a...
0 Replies
904 Views
Last post by bronco_II
Fri Feb 06, 2009 5:02 am
Explorer Leaf Springs under BII's
Replies: 1
by
orcus420 »
Sat Jan 31, 2009 4:54 pm
My BII has a small amount of rear sag and I hear the Explorer springs might be the cure. Is is true they are the same eye to eye size? Should I worry...
1 Replies
5216 Views
Last post by Ranger Dave
Sat Jan 31, 2009 6:09 pm
clutches
Replies: 5
by
djadjective »
Wed Jan 28, 2009 2:48 pm
So I have been doing some research for a tougher clutch and was wondering if anyone has had experience with any of the following in a 2.9,...
5 Replies
2326 Views
Last post by DBrown
Fri Jan 30, 2009 11:31 am
C4 tranny
Replies: 15
by
WaPaul »
Thu Jan 01, 2009 11:16 am
will the stock transfer case on a 1987 B2 2.9 4x4 (I think its a Borg Warner 1350) hook to a c4 tranny?
15 Replies
6639 Views
Last post by Ranger Dave
Fri Jan 30, 2009 5:42 am
need transmission?
Replies: 4
by
bronco2 »
Mon Oct 27, 2008 7:19 am
I have a 87 b2 4x4 automatic that I am not sure if it needs a tranie. It starts of in D great until it gets to about 20-25 then I have to put it in 2...
4 Replies
1781 Views
Last post by bronco2
Fri Jan 30, 2009 5:37 am
exhaust bolts broke
Replies: 4
by
chucknti »
Wed Jan 28, 2009 1:37 pm
ok i was taking the manifolds off and a bunch of the bolts broke off in the heads. how do i remove them? thanks
4 Replies
1837 Views
Last post by Ruffinit
Thu Jan 29, 2009 9:58 am
rebuild 3.73 rear end
by
bronco_II »
Tue Jan 27, 2009 5:39 pm
hey guys just looking for any tricks on replacing all the gears on the rear end i havnt done it before and not evan sure what any of its called all i...
0 Replies
862 Views
Last post by bronco_II
Tue Jan 27, 2009 5:39 pm
16 in rims on 1986 BII ???
Replies: 2
by
ticomic »
Mon Jan 26, 2009 10:59 am
Yo!
2 Replies
952 Views
Last post by ticomic
Tue Jan 27, 2009 9:12 am
Heater Core
Replies: 6
by
neb_scot »
Sun Jan 18, 2009 6:41 pm
Some of you will be fairly familiar with my situation in the BII with getting the engine to get and stay warm.
6 Replies
3427 Views
Last post by campcreekkennel
Mon Jan 26, 2009 1:06 pm
8 Replies
3304 Views
Last post by grizz3767
Sat Jan 24, 2009 5:03 pm
Trouble with injectors
Replies: 2
by
89BRONCOII16 »
Sat Jan 24, 2009 6:43 am
I recently had to replace my injectors and now the one all the way in the back is leaking and i cant get it to seal up. Any suggestions?
2 Replies
1210 Views
Last post by 89BRONCOII16
Sat Jan 24, 2009 4:29 pm
Frame question...
by
DBrown »
Fri Jan 23, 2009 3:41 pm
some of you know I have been working on a 76 4x4 Frame for my old tow rig. well, I was wanting some opinions on a frame decision I am trying to make...
0 Replies
977 Views
Last post by DBrown
Fri Jan 23, 2009 3:41 pm
Motorcraft 2150
Replies: 5
by
tekatlarge »
Tue Jan 20, 2009 5:23 pm
It seems to me someone was looking for information on the Ford Motorcraft 2150 Carb a while back.
5 Replies
2128 Views
Last post by clem
Thu Jan 22, 2009 4:59 pm
Parts swap question
Replies: 1
by
DEET0607 »
Tue Jan 20, 2009 11:40 am
90 bronco 2 with a rebuilt 2.9. if i keep it I will need a new transfer case(or one that works) and a few other minor parts. Mainly the transfer case...
1 Replies
947 Views
Last post by Ruffinit
Tue Jan 20, 2009 8:01 pm
POOR POWER
Replies: 4
by
DEET0607 »
Mon Jan 19, 2009 5:12 pm
I bought a 90 B2. Prev. owner said engine was knocking so he had it rebuilt, put new tires on, and painted it. I got the truck with a trans problem....
4 Replies
1740 Views
Last post by CoopertownBob
Tue Jan 20, 2009 7:17 pm
Automatic Locking Hubs Operation
Replies: 4
by
Ruffinit »
Mon Jan 19, 2009 8:44 pm
I was looking through my 84 Bronco II Shop Manual and found this information to help answer all the questions lately about the auto hub operation.....
4 Replies
8010 Views
Last post by Ruffinit
Tue Jan 20, 2009 10:47 am
New Buckets for B2
Replies: 2
by
LilnaYt207 »
Mon Jan 19, 2009 9:23 am
I'm getting two WRX bucket seats from a friend of mine, just wondering what type of fabrication will be needed to get these in the truck, and if...
2 Replies
1150 Views
Last post by LilnaYt207
Mon Jan 19, 2009 12:17 pm
Serious Electrical Fault
Replies: 7
by
neb_scot »
Fri Jan 16, 2009 7:11 am
I was wondering if someone could help me work out what could be wrong here.
7 Replies
2701 Views
Last post by neb_scot
Mon Jan 19, 2009 11:16 am
New 4in lift kit on the way
Replies: 2
by
bronco jim »
Fri Jan 16, 2009 4:18 pm
Hi Guys!!
2 Replies
941 Views
Last post by bronco jim
Mon Jan 19, 2009 9:35 am
4x4 + snow question
Replies: 11
by
neb_scot »
Tue Dec 16, 2008 11:32 am
Ive never driven a 4x4 before - and up until now have only used my BII in 2 wheel mode. However, the snow is now upon us, and given the usual fun I...
11 Replies
4520 Views
Last post by grizz3767
Sun Jan 18, 2009 5:54 pm
elc shift xfercase
by
wrencher »
Sat Jan 17, 2009 7:31 pm
i have a elc shift x case i am thinking of puting in place of my lever shift case on a 86 b2 i need 2 know how to wire it with out the factory...
0 Replies
773 Views
Last post by wrencher
Sat Jan 17, 2009 7:31 pm
VIN & DJ Sticker Decoder ?
Replies: 3
by
JoeyGowdy »
Fri Jan 16, 2009 10:53 am
Anyone know a good site to breakdown the code on the driveside door?
3 Replies
3316 Views
Last post by JoeyGowdy
Fri Jan 16, 2009 5:30 pm
3 Replies
2507 Views
Last post by LilnaYt207
Fri Jan 16, 2009 3:42 pm
5 Replies
2445 Views
Last post by Ruffinit
Fri Jan 16, 2009 2:25 pm
Tres irritating issues w/ my '89 BII 4X4.
Replies: 3
by
KD1977 »
Sat Oct 11, 2008 4:51 pm
1) The seat belt likes to stay slack while I'm driving. If I'm in & out enough, eventually it just hangs down out of the door jam when I open it. I'm...
3 Replies
1715 Views
Last post by KD1977
Fri Jan 16, 2009 2:32 am
Wont get out of 4 wheel drive!
Replies: 5
by
danny1436 »
Thu Jan 15, 2009 10:32 am
I think I'm in some trouble here. All of a sudden with no warning, I push the 4X4 button to go back to 2 wheel drive and it clicks when in gear. The...
5 Replies
1665 Views
Last post by tekatlarge
Thu Jan 15, 2009 7:01 pm
Bronco II Computer codes
Replies: 3
by
greenmachine89 »
Tue Nov 25, 2008 7:07 pm
I just scanned my computer and came up with codes 69 and 41, one says neutral switch failer or not found, the other says that the NOS2 not present....
3 Replies
1716 Views
Last post by Ruffinit
Thu Jan 15, 2009 10:40 am
doors??
Replies: 3
by
Star16 »
Thu Jan 08, 2009 9:11 pm
what doors will fit on a bronco ii?? is it only ranger doors?
3 Replies
1718 Views
Last post by tekatlarge
Tue Jan 13, 2009 3:46 pm
After Market Carb
Replies: 2
by
brestored »
Sat Jan 10, 2009 4:57 pm
Hello, I am new here. Been workin on rigs my whole life almost 40 now. One thing I have always had trouble with is after market carbs. I just bought...
2 Replies
862 Views
Last post by Ruffinit
Tue Jan 13, 2009 10:21 am
'84 Roof flex
Replies: 3
by
Ruffinit »
Wed Jan 07, 2009 10:24 am
Question to all y'all: When I'm running my '84 and have my window down at highway speeds, my roof flexes making a flexing steel sound especially with...
3 Replies
1357 Views
Last post by djadjective
Thu Jan 08, 2009 7:07 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum