Search found 244 matches
- Sun Apr 20, 2008 12:08 pm
- Forum: Tools and Fabrication
- Topic: machinist tricks
- Replies: 4
- Views: 7529
machinist tricks
Here are a few tricks and tips I've learned over the years:To find half of a fraction just double the bottom number.ie half of 5/8 is 5/16.To find the right drill to use before tapping a hole look up tap drill chart on the net. The size of a bolt is the diameter of the thread, not the size of wrench...
- Fri Apr 11, 2008 5:30 pm
- Forum: Bronco Tech
- Topic: valve cover gaskets
- Replies: 2
- Views: 1065
Re: valve cover gaskets
I've had this problem before,did you tighten them in sequence? Did you use the right torque? this really does make a differance.
- Thu Apr 03, 2008 1:14 pm
- Forum: Member Rides
- Topic: My '87 Bronco II
- Replies: 1
- Views: 1944
- Wed Apr 02, 2008 2:58 pm
- Forum: Bronco Tech
- Topic: budget lift for my bII
- Replies: 4
- Views: 1598
cheap lift
Coil springs out of a ranger stx,with auto trans and air cond have a higher spring rate,thus raising the front. Getting yor rear springs re-arched with aleaf added will do the rear.Fender trimming still req'd.This worked for me until I was ready to go big.