Search found 35 matches
- Wed Jan 28, 2009 5:58 pm
- Forum: Bronco Tech
- Topic: clutches
- Replies: 5
- Views: 1194
Re: clutches
is the Luk gold a multi-Friction clutch?
- Wed Jan 28, 2009 2:48 pm
- Forum: Bronco Tech
- Topic: clutches
- Replies: 5
- Views: 1194
clutches
So I have been doing some research for a tougher clutch and was wondering if anyone has had experience with any of the following in a 2.9,
Centerforce Dual Friction
Zoom Hi Performance Kevlar
Luk Gold Series
Centerforce Dual Friction
Zoom Hi Performance Kevlar
Luk Gold Series
- Thu Jan 08, 2009 7:07 pm
- Forum: Bronco Tech
- Topic: '84 Roof flex
- Replies: 3
- Views: 745
Re: '84 Roof flex
Yeah I used Hurculiner, 2 gallons did the inside, outside, prerunner bumper, and tire carrier. That'll take care of any new rust for a while haha.
- Thu Jan 08, 2009 7:15 am
- Forum: Bronco Tech
- Topic: Keeping the engine warm in winter
- Replies: 6
- Views: 1156
Re: Keeping the engine warm in winter
I found a winter front from what I think is one of the only companies making one for a bronco II, Fia. An auto parts or a 4x4 store should be able to special order one, but I think you can get one through Fia online. They use stickon tabs so you can remove the front but still have the tabs mounted t...
- Wed Jan 07, 2009 11:09 pm
- Forum: Bronco Tech
- Topic: '84 Roof flex
- Replies: 3
- Views: 745
Re: '84 Roof flex
I get that same loud popping noise when i'm going down the highway with high winds or with my windows down and mines a 88, After I bedlined my truck (roof included) I only heard the noise once but there was some really bad gusts going on. I think a roof rack would help with the flex.
- Sat Oct 25, 2008 3:51 pm
- Forum: Bronco Tech
- Topic: under dash leak
- Replies: 3
- Views: 921
Re: under dash leak
I removed the blower motor and after cutting through some of the mesh behind it, I removed what seemed like a few pounds of black wet compost, leaves, and sticks. Then I found a drain port to the right of the blower motor housing and used some wire to clean that up. Not sure if it will work yet, aft...
- Sat Oct 25, 2008 11:44 am
- Forum: Bronco Tech
- Topic: 88 BII will not stay running
- Replies: 8
- Views: 1257
Re: 88 BII will not stay running
I experienced this problem when my Ignition Module started going out and knocked my timing way off to the point where it would sputter for a minute till it would finally turn over and run like crap and then die if i wasn't giving it any gas. I would have your module checked, and also check your timi...
- Wed Oct 22, 2008 5:24 pm
- Forum: Bronco Tech
- Topic: under dash leak
- Replies: 3
- Views: 921
under dash leak
I seem to have gotten this problem that when it rains a lot of water ends up in my truck. After a storm and as soon as I get my truck moving about a quart or water pours out onto the floor from under the passenger dash. the only thing I can think of is that my ventilation duct in front of the windsh...
- Sat Feb 09, 2008 2:03 pm
- Forum: Bronco Tech
- Topic: Blower motor housing and leaves
- Replies: 3
- Views: 1166
- Fri Feb 01, 2008 6:24 pm
- Forum: Bronco Tech
- Topic: Blower motor housing and leaves
- Replies: 3
- Views: 1166
Blower motor housing and leaves
Today I had to replace my blower motor, at least it waited to die on me after the temperatures got above 0. Anyway, when I removed the blower motor and the fan, I noticed a lot of leaves and twigs wedged between two metal screens going into the heat ducts, What is the best way to get them out, becau...
- Fri Dec 28, 2007 3:21 pm
- Forum: Bronco Tech
- Topic: Battery,cellenoid, starter, or something else?
- Replies: 8
- Views: 2120
I had the same thing happen to me once, the selenoid would just click and I got no noise from the starter. I replaced the selenoid and havent had issues since. Even though it was clicking it wasnt sending any voltage to the starter. But I would make sure your battery is fully charged first and then ...
- Fri Dec 21, 2007 4:50 pm
- Forum: Bronco Tech
- Topic: Axle Upgrade
- Replies: 5
- Views: 1506
- Thu Dec 20, 2007 6:58 pm
- Forum: Bronco Tech
- Topic: Axle Upgrade
- Replies: 5
- Views: 1506
- Thu Dec 20, 2007 5:36 pm
- Forum: Bronco Tech
- Topic: Axle Upgrade
- Replies: 5
- Views: 1506
Axle Upgrade
In the spring Im going to replace my leaf springs on my 88 Bronco II and a friend of mine has a Ford 8.8 sitting around he doesnt need. So my question is what would need to be customized with that axle swap; U-bolts, Driveshaft, shock mounts? Also what would be the best choice one out of a ranger or...
- Wed Oct 03, 2007 12:40 pm
- Forum: Bronco Tech
- Topic: engine hard to start, and when it starts, idle fluxciates fo
- Replies: 14
- Views: 3679