BroncoII4x4.com

My truck is doing this, and since noticing, I've seen other fords acting the same.... When the wheels are turned, the outside tire leans outward causing the outside edge of the tire to wear faster than the inside. I just put new wheel bearings in it, but like I said, the tire physically leans when t...

My "garage" as I'm calling it-- has no power. I need to get some light in there.

I have a car battery sitting around and a light fixture and switch. Can I put a 12 volt dc bulb and circuit it up to the battery?? will it burn my barn down or what? Fuses?

the dimmer switch works. The dash lights brighten and dim with the switch. how would i put a voltmeter on door switches to test them?

ok.. not that retarded

I went this weekend! My buddy brought his camcorder but we eventually turned it off. It was bad luck to record anyhting!! :rolleyes2: the motor would get wet and cut off, then two minutes later start right up! :wtf: i don't know why..... also accidentally jumped that bad b*tch! LOL i was just tryin ...

I'm half retarded when it comes to electrical troubleshooting. I don't feel bad saying that because a lot of you are too! HA Interior lights stay on all the time.. had to take the bulbs out. so, how do i check to find out what is causing the problem??

Went and got some new wheels. Aluminum off the same ranger I got the tranny from. I got a feeling the noise I'm hearing is one of the motor mounts going bad.I guess next paycheck I'll be fixing that!

I heard the axles from the pickup were stronger. Would it even be worth doing if the biggest tires Im getting would be 31's?

They're both 4x4. So the rear would need some cutting a welding? And the front is just a bolt job?

Will front and rear axles from a '92 ext. cab ranger bolt onto an '88 b2 xlt?

After driving her around for a while, I can say that every time the truck's weight is shifted to the left, it makes the noise. (Right turns, when the truck is rocking) I can't say for sure the axle or DS or trans is to blame, but I mainly feel the vibration through the gas pedal. It doesn't make a d...

Here's the bad news. When I took off after fixin the carpet and all, I didn't notice i left the transfer case in 4L. So when it wasn't speeding up right I hit the gas a lil bit, which threw my foot back and repeated 3 times, :mad: then shifted to second and threw the transfer case to 2H without clut...

Mazda tranny is installed! :D I got it on without takin the crossover pipes off. The manual transfer case shifter was in the same spot, but the gear shifter ended up about two inches closer to the motor. I cut the plate that was bolted to the floor and trimmed the plastic that the boots attach to an...

I'm probably jumping the gun on this since my trucks not drivin yet.. but i'm trying to find cheap ways to lift my b2. If i put explorer springs in the front, would i need to do anything with the pitman arm or radius arms?

Got the tranny last weekend. The shifters are different and the two electrical connections are on the opposite side. Shouldn't matter since my wires seemed to have enough slack. The mazda trans is about a half inch taller. I ended up cutting the crossover pipe on the ranger to get the trans out. Whe...