BroncoII4x4.com

Using oil is good, also use the right drill for the tap, there are alot of tap drill charts online. Remember to go slow with the tap and clear the chips often by going backwards after every 1/2 to 3/4 turn. Do not reverse the reamer this will dull it, just go slow. Use something square to keep the t...

I would have somebody see if your rear drive shaft is turningwhile in gear. My pinion yoke stripped the spline and it would not move, just make a grinding noise. All I had to do was replace the yoke from Ford.

Was it the connections? Did you get it fixed? If not check those grounds!

Wishing all a Merry Christmas and happy and successful New Year.

X2 Just buy new parts for this.

Well it takes me awhile, But I do make some progress, I still got to do the other side. [img]C:\Documents%20and%20Settings\user\My%20Documents\My%20Pictures\2009_1206junk\2009_1206junk0075.JPG[/img] These are my upper coil mounts. Its not bolted in yet but now that it cooler here Ic an go back to wo...

Synthetic oil in your engine and differentials will help, I'm not sure about it in an auto tranny or any tranny as far as that goes. Make sure your tires are the right size and are inflated properly. A k&n or similar type air filter is SUPPOSE to help with fuel mileage. This may sound stupid but...

Congrats!! Imagine, A little onewontwo-jr running around building hopped up little wagons and such. Cheers

I think tek noticed the fuel line in his post. I came into the same situation when I replaced the engine in the vw van, I had gas running down my arm and pooling on the floor and all I could think of is what could make a spark? The compressor! So I rolled over on the air ratchet and dam near shit my...

Stupid new computer! Seems slower that my old one.

With 33's I would go with 4:10's or 4:11's I can't remember which one ford put in the rangers. But going from 3:73's to 4:88 seems a little much to me.

Have you done a load test on the battery? an engine that starts quick does not draw a lot on the battery, but when you crank a bit, a bad battery will show it's flaws.

Sorry, I forgot that part, thanks Dave. As for my bii, I'm doing the sas, 5.0L and some other mods at the same time as well as keeping the other rigs running.

http://en.wikipedia.org/wiki/Leak-down_tester
A little reading for ya

What are you going to use for springs? Anything is possible hows your welding skills?