BroncoII4x4.com

I need your advice to help change a stuck ignition cylinder. The Bronco II ignition key will move from Accessory mode enough to start the engine but...

Been having some issues with my BII where it’d sort of stall out for a second a stop lights and such. Weird rough idles and fluctuating RPM. Read...

Had recently rebuilt my 87 BII 2.9L . New Heads, gaskets, Distributor, wires, plugs, etc,.. I had a fuel leak at the filter and replaced the...

My newly acquired rig has been running fine, but when checking the oil, it was very very dirty. A quick valve cover gaskets replacement, oil change,...

I’ve got an 84 with the TFI that I desperately need to get rid of. I was going to do the duraspark swap, but quickly found getting a distributor is...

i have a bronco 2-90. m50d gearbox and bw1350 transfer case. what needs to be changed and where to make the pto work.

still have it

Hi there,

Just picked up a 90 B2 manual 4wd and running into a weird issue - neither turn signal works.

The 4-ways worl properly so I know it's not...

The 87 with the 2.9 and 5 spd has different fitting on the clutch hose are the other years compatible or can I get away with changing the slave cyl...

I hope someone can help me.
I have a Bronco 5.0 4x4 (1989 model).
One day there was a lot of oil under my car. Looking underneath, I saw drops of oil...

Long time no post. Thanks for all the help from Tek and Drof and others back in the day when I was rebuilding my 2.9. :cool:

Took a trip to the...

HEY THERE.. IVE BEEN COMING TO THIS SITE FOR SOME TIME, BUT IT DOES SEEM A BIT QUIET IN HERE. ANYWAY, I POSTED A TECH QUESTION AND WOULD APPRECIATE...

Hello everyone. First time Bronco owner, first time poster. Just came into posession of an 89 Bronco 2 XLT and the bushings in the wiper linkage are...

I’m about to do a 4.0 swap in a 1990 bronco2. The donor engine is a 92 explorer. I think I’ve done most of the research but any pointers are...

My 87 bronco 2 idles like a champ but if I feather the gas it'll bog out. Usually, I can rev it up but it'll just start to die off. I replaced the...

New to group. I have a 87 standard and I get a ticking noise coming from front right hub area, this noise goes away when put in 4 wheel drive? Thks

Evening,

Just bought a 85 BII Eddie bauer edition with 80,000 on a rebuilt engine and tranny. So for my question, fuel gauge is erratic says full...

Back in '99 I bought my '84 Bronco II from this guy that got it in an auction as part of a lot of construction equipment. It sorta ran. Enought to...

Need a little help here, I pulled out my trans (FM146 5 speed) and did the 4.0 clutch upgrade with no problems. Recently I pulled the trans for a...

I have a transfer case which I believe is based on the Borg-Warner 13-54 transfer case (see pictures) From my research I believe the Borg-Warner...

My b2 came with ac but it was stripped of much of it including wiring. Only thing they left is the black housing on passenger side firewall. At my...

And Blah Blah Blah

Hi everyone Its winter and I started my project a few weeks ago. I am repainting my 87 B2 I brought it in the garage and tore it down and started...

Bronco ii '89 2wd automatic with A4LD
Swapped front axle with '92 explorer 4wd - no issues here
4WD harness and shift control module out of a '91...

I have about had enough of internet host providers. I am beginning to believe that there is not 1 god provider out there. of course maybe I am being...

I have a 1990 BII with some issues. Just wonderin if the 92 Ranger is for the most part interchangeable with my Bronco (engine, trans., transfer...

So I joined today, yet another B2 forum! I have had a few of theses little trucks, love my 1990. Here is a pic of her;...

I wanted to remind everyone of the All Ford Car Show and Ford Model car contest June 21 in Columbia MO. Shady Park setting. Some special give a ways...

OK Still waiting to get B2 out of transmission shop, got a call Fri. they are waiting on parts should be ready by Wed.
We will be keeping everyone...