BroncoII4x4.com

Thanks, we got it working. there was a loose wire pin in the harness/plug.

I have an 87 Broncoii and the 4wd "touch drive" switch will not light up, the courtesy light inside the switch does light up when you turn the headlights on. Evidently there is no power going to the switch. I have tried to find a fuse for it but the manual does not identify any fuses for t...

My 87 Bronco ii is having some issues. When I am driving sometimes it starts to miss and runs rough and when I give it gas it takes right off and runs strong. It is very inconsistent in when it does it. I put it on OBD1 scanner and it came up EGR valve. The cats are gutted and there are no O2 sensor...

probably just the front seal dried up from sitting. I just replaced mine for the same problem, it cost under $10 BUT the trans has to be removed to do it so it is a little work. The way to tell is fill it back up with tranny fluid and see if it functions properly before it leaks out again.

I did get a ujoint style driveshaft and I will have to shorten it since it came out of a manual trans but no big deal. I cut the lift blocks at more of an angle to rotate the differential up to decrease the angle. After seeing your comment about the pinion gears and lubrication I have some concerns....

I put 4" lift blocks on the rear of my 87 Bronco 2 today and when I was done the rear driveshaft was too short. I lengthened it the correct amount and it was better BUT the angle on the cv joints is so extreme that after about 5 miles the front cv joint on the driveshaft started making a hell o...