BroncoII4x4.com

ok so try turnin the crankshaft jus a little so the gears and shaft match correctly?

I removed my distributor so I could replace it but I didn't set the engine to top dead center and now the distributor will not mesh up properly with the cam gears and oil pump. any help would appreciated.

yes i have fuel, i replaced the distributor becuase the tfi was bad. no it doesnt sputter or anything

so i jus replaced the distributor and wired the plugs correctly but it still wont start and it gets fuel but wont run. ive tried spraying carb cleaner in the intake and still didnt do anything. any help would be appricatied.

how do i test to see if i have spark at the coil?

I have an 87 b2 2.9lt v6, all the stuff inside if the distributor cap is corroded as well as the tfi

ok so i removed the distributer and the tfi and there was alot of corrosion on the points and rotor in the distributer and when i took the tfi off there was alot on that too. what would be my next step, just buying a new distributer?

ok so i did the test with the starter fluid and it didnt turn over at all, so its a spark problem and it think it is the distributer but thats my guess. any suggestions as to what it is?

a shop did the flywheel and i checked all the grounds and there good. i think its something in the igntion switch. beacuase it wont start when i turn the key but one time i turnd the key the other way and it started.

yes i got it to turn over but it still wont crank and the fuel pumps work fin as-well as the starter

ive replaced the fuel pump on my b2 and it ran great but then my flywheel broke so we replaced that and once i got it back it wont even crankz ive charged the battery and electrical all worksz i have no idea whats wrong, any help would be appreicatiated