Mine, A 1987 Bronco II did the same thing
it was axle wrap that caused it to happen!
5" of lift, 3" leafs and 2" blocks
I put on Anti wrap/Traction bars and havent had the problem since
Search found 26 matches
- Thu Apr 19, 2007 6:42 pm
- Forum: Bronco Tech
- Topic: Need Help!! Transfer case cracked
- Replies: 3
- Views: 1132
- Thu Apr 05, 2007 12:34 pm
- Forum: Bronco Tech
- Topic: help with alternators
- Replies: 3
- Views: 1089
So If I were to upgrade to an 80A alternator, should also change the wiring and the voltage regulator? Thanks. on late 86s regulator is internal wireing is the same but replace the power outlet plug and use a lot of Dielectric Grease on early 86s same regulator same wireing but between the two two ...
- Wed Apr 04, 2007 5:36 pm
- Forum: Bronco Tech
- Topic: help with alternators
- Replies: 3
- Views: 1089
- Fri Feb 16, 2007 6:46 am
- Forum: Bronco Tech
- Topic: Serious Hesitation Problem
- Replies: 17
- Views: 3552
- Wed Feb 07, 2007 9:17 am
- Forum: Bronco Tech
- Topic: runs but wont idle
- Replies: 9
- Views: 2043
- Fri Feb 02, 2007 1:48 pm
- Forum: Bronco Tech
- Topic: axle swap
- Replies: 2
- Views: 1057
- Fri Feb 02, 2007 7:34 am
- Forum: Bronco Tech
- Topic: Electrical Click
- Replies: 10
- Views: 2061
- Fri Feb 02, 2007 7:24 am
- Forum: Bronco Tech
- Topic: explorer springs??
- Replies: 3
- Views: 1241
- Fri Feb 02, 2007 7:16 am
- Forum: Bronco Tech
- Topic: wtf do you mean cracked heads?!?! i said i had no heat!!!
- Replies: 35
- Views: 5791
Head cracks are less likely in the later models but it could be take it to a shop where they can test for combustion gasses in the rad. next step air in heater core or clogged, take off return hose at the heater core, run engine, and see if you get air or nothing if nothing replace heater core check...
- Fri Feb 02, 2007 7:07 am
- Forum: Bronco Tech
- Topic: Is injector cleaning service worth a darned?
- Replies: 8
- Views: 1755
- Tue Jan 09, 2007 7:05 am
- Forum: Bronco Tech
- Topic: Drive Shaft
- Replies: 25
- Views: 6087
QUESTION: on the james duff website, it specifies two dshafts, short and long, but only for 86 - 89. i have a 90, manual trans, do i need the short or the long? I don't know which i need. in the picture posted on page 1 of this thread, by mr. hair, is the top one, the double cardan the short one, a...
- Thu Jan 04, 2007 1:48 pm
- Forum: Bronco Tech
- Topic: Ignition troubles? Please help!
- Replies: 13
- Views: 3039
un hooking the o2 censor isent going to solve anything it will either way lean out the engine or make it run way to rich you cant just do away with them I did away with mine for a couple months with out a problem. Once it was gone, it idled much smoother. I later replaced it. If you unhook the O2 s...
- Thu Jan 04, 2007 1:38 pm
- Forum: Bronco Tech
- Topic: D35 swap
- Replies: 11
- Views: 2746
- Wed Jan 03, 2007 10:57 am
- Forum: Bronco Tech
- Topic: Ignition troubles? Please help!
- Replies: 13
- Views: 3039
- Sun Dec 31, 2006 3:10 pm
- Forum: Bronco Tech
- Topic: o2 sensor
- Replies: 3
- Views: 1090