BroncoII4x4.com

check the wiring connections by the tranfer case under b2 disengauge the plug check for corrosion that where my problem was
also look for broken wires same area
rochhound

finally found my aliginment problem, my b2 had been rear ended passanger side bringing the wheel well forward
1/2" so i used my tractor and a winch and pulled the passanger side back in place end of tire rubbing in wheel well !

no wreck and in fact i checked it for damage when i cleaned it and painted it be for install. when the wheels are staight and i put my hand rear of the wheel well both sides i have more clearance on drivers side than on pasenger side about 3/8" im going to have to check dimensions from my ranger ...

ive completed installing my dana 35 in my bII i used the dana 35 springs about 2" higher. im having a clearance problem on passenger side tire rubing rear of the wheel well when i turn rite the tires are 7.5 x 15" im thinking maybe because of the lift its throwing the tire to far back,maybe putting ...

i tryd ebay nothing used and some dealers advertise jeep ford etc but when emailed them they want double the money
from $150. TO OVER $300. +

im installing a dana 35 in my b2 my only hang up is the dana 35 is the wrong ratio so i need to get a set of 4:10s so far pretty
pricey about $300.00, can any body tell me a good site or place to get reasonable or is this in the ball park

thanks

i had the same problem with my 86 ranger it turned to be a ground wire not hooked up, ties down on the side of the intake above the above injectors
good luck

ive purchased a dana 35 axle complete out of a 1990 explorer for 88 b2, made sure it wasnt a dana 28 inerds thanks site for all the great dana 35 info! now im looking for ring and pinon 4:11 and i also looking for a jeep dana 35 trac lock what year jeep and models used the 35 trac lock . also will ...

hi have 88 b2 and im going to replace the dana 28 with explorer 1993 front suspension d35 is there a limited slip,or trac lock available i dont want a wheel drager in front but two wheel posi so i can use in mud snow or pavement.
thanks rockhound

thanks pigmy appreciated ill start looking
rockhound

thanks for the info but are the early explorer, dana 35 ,and will i be able to install a limited slip in a dana 35
thanks rockhound

no there not 2x4 are longer youll have to do a total tare down and get a short shaft lots of work

i have a 88 b2 4wd 2.9 my front axle is dana28 i want to replace axle with something i can install limited slip in (front) ive been told an explorer axle will fit is this true and what years will work? i understand that i will have to match ratio thats a no brainer,and this is not a rock crawler i ...