BroncoII4x4.com

cool thanks that helps a lot. my first idea was that the spring was sagging or something. because i did check the ball joints and bearings and they are just fine. and i noticed on the spring perch that it was kind of torn up so i think that i will go get a leveling key for the front end.

that was only on explorers where they teamed up with ford. Not Bronco II's And if you remember they didnt have that problem until they stopped making bronco II's all together. The reason the tires were blowing up was they told firestone to try to make a tire that will sutain a low PSI rating. then t...

My 86 EB has an alignment problem only on the right front tire. It is wearing out on the inside and it also sits lower. I didnt think that camber would effect ride hight. So what can i do to fix it at home or identify if somethiing is crewed up?

What the heck are you doing putting 45 pounds of preassure in your tires. It is only supposed to be at most 35 PSI. Check your door jam!

i replaced the low preassure pump in mine and it fixed that very same problem.

i'll but it off you if you want to sell it

Hey i noticed you live in selah WA i do too, maybe i can come over and take a look at it for you and see if i can find the problem.

So did you replace the pump in the tank or did you just replace the sock filter. cause if you took it out should have tested the pump in the bench to see if it pumps with power and ground.

So does the bronco II cut out when going up hills or when heavy on the gas? And how can you say there isnt a fuel system problem. they just didnt catch it, it only happens every once in a while right. How long has it been acting up? My truck was acting up for several months and gradualy getting wors...

I would recomend doing a fuel preassure check and make that when it runs bad you see that the fuel preassure is bad. should be btween 35-45 psi. I had the same problem and just recently got it fixed. I replaced the in tank fuel pump and it still is running good. What do you mean, you have been throu...

yeah both of the filters on are on the driver side frame rail. I am having the same problem and i replaced the high pressure pump and the low preassure pump and bothe filters and it still sucks and wont run. but i have figured out that the low pump in the tank is running but not sending fuel. that w...

Ok i replaced both filters and that includes the cartride filter. which i thought was the problem. Then i tried to start the truck and it only had 10 psi and wouldnt start. we pulled one of the fuel lines off and there was no fuel. :wtf: So i unplugged the high pressure oump and hot wired the low pr...

ok now the bronco has two new fuel pumps and it still hesitates. the fuel preassure goes down to 10 psi so now i need to check while the pump is running low preassure voltage at the pump and see if recieving proper power. if it does drop power only at operating temp does anybody think that it could ...

hey i tested the rear pump and hooked up 12 volts to the conection in several places and could not get the fuel pump to run so i am going to go buy a pump and seew what happens now.

Ok my truck runs at about 31 or 32 psi and runs and drives ok. then sometimes when under load and at operating temp it cuts out barely runs and the fuel preassure goes to 5 psi and sits there until it figures out how to fix itself or the connections gets better. i have relplaced the high preassure f...