BroncoII4x4.com

seriously nobody knows the answer? I know a few of you have done the swap so what did you do?

look under your BII and see if there is a "transfer case" I am not sure about the '90's one but up to '88 for sure any BII that was 2x4 had a hollowed out t-case and if that's the case with yours all you need to do is go to a junkyard and get the T-case from any BII(probably easier to use a manual ...

Ok so I FINALLY have the money to finish my second 5.0L BII install and I have a carbed 5.0 in a '90 bII FRAME/body was wondering if anyone knew if the Sending unit/fuel pump for a '84 would fit the '90 fuel tank so I can just change the in tank pump to the one designed for a carb My other thought ...

if you are going to go through all the work I highly recomend the v8 swap... TONS more power and better fuel economy than 2.9

when I build custom fit speaker sub boxes I make a frame for the box then use pantyhose stretched over it to get nice flowing "molded" edges results are fantastic

so I am still looking for the length of a bw1350 if anyone has one handy to measure

just thought id mention that with a zf and bw1356 the driveshaft length I would need to run is 18" which is why I don't think its a great choice :p

yea but then I need to either make a separate T-Case Crossmember or change the tranny as the ZF cant handle the weight of the np205.. also I dont have room to use a divorced 205 and its hard to find a married one I like your whole writeup btw shows people it can be done on the cheap.. If I decide to ...

yea not a lot of other choices though... iv spent hours trying to figure out what will fit and all I can come up with is a np205 or use an Advance Adapters adapter for bw1350

I am in the midst of figuring out what tranny/t-case to use for my BII v-8 swap... I have a ZF-5 married to a 1356 and I know the 1356 is 16 5/8" from front mounting plate to rear U-joint mounting plate Was wondering if someone could tell me the dimensions of a BW1350 front mounting plate to u-joint ...

175lbs shipped UPS freight would be $650 USD lol

I ship stuff across Canada(2700miles) all the time for $40 CDN for 120lbs/pallet Ill check into it later to see if I can find a decent freight company for the U.S. :p

none that i know of that will fit with out cuttin the frame. theres is a 435/D20 combo,but ya need a adapter. i have one for sale http://nh.craigslist.org/pts/2330115024.html http://rangerdave.freeforums.org/dana20-to-a-np435-t262.html I would totally buy that but unfortunately I am in Vancouver BC ...

have you replaced the in tank pump yet?

thanks for the help... is there any other Transfer cases that fit under the BII nicely and mate to the NP435?

Sorry about that.. I had done it before so it made complete sense with the little bits of info on my first link ok I found a link that describes the process a bit better... even describes how to do it without switching the yoke from the exploder on my BII I used a driveshaft from a second gen and ...