bronco11

Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
Post Reply
trapper
Posts: 1
Joined: Sun May 18, 2014 5:55 pm

bronco11

Post by trapper »

I just bought an 89 bronco11 15000 miles. It is useing water, but can't find any leakage, no moisture in the oil, do I have cracked head and it's going out the exhaust? thanks
Slammin Sam
Posts: 8
Joined: Tue Oct 15, 2013 2:29 pm
Location: fruita, co

Re: bronco11

Post by Slammin Sam »

In months or searching for my current B2, I realized that a B2 low on coolant almost always had a blown head gasket or cracked head. One easy way to check, warm up the engine. Carefully remove the radiator cap. Put a latex glove over the filler, secure it with a tight rubber band. Plug the overflow hose. Pull the coil wire. Crank the engine and watch the glove. If it inflates you need a head gasket or a head. If you need to replace a head, be sure you get one from an 89 or newer 2.9 Ford redesigned the casting in 89 to try to avoid the cracked heads. Obviously, it doesn't always work!
Post Reply