Ask technical questions about your Ford Bronco II here. Technical write-ups on your axle swaps, engine swaps, chop tops, etc. are encouraged.
60s
Replies: 9
by
wilber »
Wed May 26, 2004 6:49 pm
i thought someone on here had a 60 in a b2, and it was coil sprung.
9 Replies
3290 Views
Last post by MUD1986
Sat Jun 05, 2004 7:50 pm
np435 hydro clutch
Replies: 3
by
wilber »
Sun May 30, 2004 2:08 pm
finaly got it in and the slave on, i belive its all from a 79, ill have to check with alx to make sure.
3 Replies
1858 Views
Last post by wilber
Wed Jun 02, 2004 5:33 pm
D44 and 9" from a 79 ford
Replies: 22
by
Phillippi »
Sat May 01, 2004 6:28 pm
how does $300 for the set sound for FS Dana 44 disc and 9 rear? I have a guy near me that is selling these and he says they are in good shape....
22 Replies
7422 Views
Last post by wilber
Sat May 29, 2004 3:13 pm
NP435 problem
Replies: 3
by
DBrown »
Wed May 26, 2004 5:13 pm
I got the motor running on the 79, but when I started to mess with the tranny I ran into a problem. all the forward gears work fine, but when you put...
3 Replies
1912 Views
Last post by DBrown
Wed May 26, 2004 6:55 pm
Fm145? Fm146?
by
Wicked Bronco II »
Wed May 26, 2004 3:06 pm
Other than the 145 is 4wd only and 146 is 2wd and 4wd are there any differances between the two?.. which is better?? Thanks for the input
0 Replies
1987 Views
Last post by Wicked Bronco II
Wed May 26, 2004 3:06 pm
thought of this today...
Replies: 5
by
DBrown »
Sun May 23, 2004 10:37 pm
I was thinking of ways to set up my rear suspension today and I thought I would run this by y'all.
5 Replies
2253 Views
Last post by Rockcrawler
Wed May 26, 2004 12:48 pm
fuel prblems???
Replies: 12
by
huffs »
Fri May 14, 2004 10:09 pm
My truck is an 86 bronco2 with a 2.9l 4speed with od. my problem is kinda wierd. If i start up the truck and let it idle it will start with high idle...
12 Replies
4112 Views
Last post by huffs
Wed May 26, 2004 3:52 am
whats under this
Replies: 1
by
madmark »
Tue May 25, 2004 9:30 pm
HI evrybody
1 Replies
1240 Views
Last post by Nobody
Tue May 25, 2004 10:00 pm
got my locker.
Replies: 4
by
PHROX »
Mon May 24, 2004 8:08 am
yep, got my locker and 5.13 gears in, the handling is very different, I was just wondering if you guys running lockers also got wierd handling. I am...
4 Replies
1920 Views
Last post by PHROX
Tue May 25, 2004 4:22 pm
ECM Wiring
Replies: 1
by
MHHodges11 »
Tue May 25, 2004 8:37 am
Does anyone know where I can find a wiring schematic for an ECM computer in an 84B2. My project has only one of the o2 sensors wired in and I need to...
1 Replies
1499 Views
Last post by DBrown
Tue May 25, 2004 3:09 pm
rear driveshaft trouble!
Replies: 13
by
MXjunk127 »
Wed Apr 21, 2004 5:22 pm
Well, My Broncs rear driveshaft broke into a whole lot of peices. I think Its because when the previous owner put the lift on it, The driveshaft did...
13 Replies
4910 Views
Last post by unfknreal
Tue May 25, 2004 9:15 am
What to do first?
Replies: 8
by
Bronco19 »
Sat May 22, 2004 4:47 pm
I'm a little unsure exactly what I should do first. I'm wanting to hit the trails and not look like a total idiot. Right now I have 33/12.5 street...
8 Replies
2991 Views
Last post by Phillippi
Mon May 24, 2004 6:42 pm
Does Dana 35 off Explorer work on 89B2?
Replies: 30
by Bronco19 » Wed May 12, 2004 11:10 am
Does anyone know for sure if a Dana 35 from a 91'-94' Explorer is a direct swap for my 89' 2wd B2? I've heard something about the pivot brackets...
30 Replies
11527 Views
Last post by bigswede
Mon May 24, 2004 3:47 pm
2 Replies
1838 Views
Last post by DBrown
Sun May 23, 2004 9:14 pm
Swamp_DonKey Trouble! How to hot wire a 2.9
Replies: 3
by vj_M » Fri May 07, 2004 4:58 pm
How can i hot wire a 2.9
3 Replies
2086 Views
Last post by VJ_M
Thu May 20, 2004 4:50 pm
headers
Replies: 2
by
808 bronco »
Sat May 01, 2004 11:18 am
hey fellow broncees,
2 Replies
1969 Views
Last post by Guest
Wed May 19, 2004 11:37 am
wristed arm question's
Replies: 11
by
FatMan »
Sun May 02, 2004 3:06 pm
okay, okay, okay :D
11 Replies
3625 Views
Last post by FatMan
Mon May 17, 2004 9:31 pm
Leaking gas problems
Replies: 7
by Visitor » Wed May 12, 2004 8:10 pm
Hi There,
7 Replies
3147 Views
Last post by Guest
Mon May 17, 2004 1:49 pm
Cleaning out my O2 sensors?
Replies: 7
by
Rockcrawler »
Sun Apr 18, 2004 10:43 pm
How can i clean them with out damnageing them? I put this post up to because i wanted to be the first one to post in here! :lol:
7 Replies
3968 Views
Last post by MHHodges
Sun May 16, 2004 9:26 pm
Bronco 2 spark problems
Replies: 6
by vj_M » Sat May 01, 2004 5:13 pm
ok, I replaced the TFI module, tryed a diferent coil and still i have no spark....
6 Replies
2713 Views
Last post by huffs
Fri May 14, 2004 9:57 pm
4 Replies
2369 Views
Last post by Nobody
Thu May 13, 2004 10:03 am
U joint question...
Replies: 2
by
PHROX »
Wed May 12, 2004 5:27 am
on my d44 I just blew out the berings on the drivers side u joint. is it possible to switch out the u joint without removing the axel shaft?
2 Replies
2028 Views
Last post by PHROX
Thu May 13, 2004 6:55 am
Flip'n a toyota?
Replies: 2
by
NightKrawler »
Sat May 08, 2004 6:45 am
Posibility or crazy idea?
2 Replies
2097 Views
Last post by Rockcrawler
Mon May 10, 2004 2:36 pm
check this out....
Replies: 2
by
DBrown »
Fri May 07, 2004 5:46 am
I found this tread over at a FSB forum. the guy is running a stearing setup on the backof his axle. do y'all think this might work for coil sprung...
2 Replies
1952 Views
Last post by Rockcrawler
Fri May 07, 2004 11:22 pm
High revving motor
Replies: 7
by
ran429 »
Thu May 06, 2004 12:26 pm
I cant seem to figure out why my engine wont idle down .
7 Replies
3107 Views
Last post by ran429
Fri May 07, 2004 7:43 am
Switching to a Dana44
Replies: 2
by
nettak »
Tue May 04, 2004 9:08 pm
So what all is involved in switching to Dana44? Where do I look for one? How do I know what I'm getting? I wonder if I can do this myself. :confused:
2 Replies
2300 Views
Last post by foxfan
Wed May 05, 2004 3:34 pm
lift kit
Replies: 9
by
89b24x4project »
Mon May 03, 2004 5:38 pm
ok i want a good all around lift kit so i can run on my deer lease its got rocks and ditches hills and lots of mud how high should i go and what...
9 Replies
4452 Views
Last post by foxfan
Wed May 05, 2004 3:23 pm
Drive shaft lengths?
Replies: 2
by Burnside » Tue May 04, 2004 9:30 am
Alright fellas, I got a 1989 bII with the a4ld and 6 skyjacker lift. d35 front axle, 7.5 rear. I have the tcase from an 84 ranger. the rear...
2 Replies
2085 Views
Last post by Blue_coyote
Tue May 04, 2004 10:12 am
New to off-roading
Replies: 12
by Guest » Sat May 01, 2004 1:43 pm
Hello. I know i posted this on the ABS topic but i figured since that question had been answered i didnt know if anyone had read mine. Im new to...
12 Replies
4636 Views
Last post by Guest
Mon May 03, 2004 3:29 pm
Spring length?
Replies: 3
by
PHROX »
Wed Apr 28, 2004 3:05 pm
Hey, anyone with a solid axel and good flex out of it.... can you post the springs you are using and thier compressed lenght? thanks...
3 Replies
2107 Views
Last post by FatMan
Sat May 01, 2004 5:41 pm
Forum permissions
You cannot post new topics in this forumcannot reply to topics in this forumcannot edit your posts in this forumcannot delete your posts in this forumcannot post attachments in this forum